Disco ball day!





Today was the day I brought in my DISCO BALL! I decided to spice up my Boat Building life. Everyone loved my disco ball speaker. I blasted a bunch of tunes and sang out loud. It made the sanding process so much more fun. I spent the entire seven hours of my day sanding, sanding, sanding, sanding. Was it fun? I’d definitely say the sanding wasn’t. But the party was a blast. Lisa P came to check in on me, and so did Becky Walsh! Great friends to have visit! Hurricane by Luke Bryant was my favorite song of the day!



Comments

Post a Comment

Popular posts from this blog

Image
Today I woke up, headed to the Boat-Building Shop, and started my first day on my Senior Project. I've been working on my boat for two years now, and the time has come for the final few steps to be put into action. I am so eager to finish it up. Right when I walked in to see my Eastport Pram, I knew what I had to do: 1. Remove the clamps from my doublers. 2. Sand the handles of the bow and stern. 3. Work on filleting the internal frames. 4. Install the motor pad and scrape up the oozing epoxy. There were some dents when removing the claps, so a quick sanding came in handy. I used a heat gun and scrapper to remove access/dried epoxy around the edges of the doubler. My first go at filleting the frames turned out pretty nice “looking”, but not dense and supportive enough. This led me to add another supporting layer of extra-thickened epoxy. The end of the day came in fast, so I quickly spread unthickened epoxy on the motor pad's surface, then quickly mixed up some thickened epoxy
Read more

Boat Building Day 2

Image
I stormed into my second day of Senior Project with the intent to prep my boat for the installation of my seats.  With my two doublers installed, I had to fill in a few gaps to make the walls flush. I also coated both air chambers with epoxy.  I added a few more fillets and started sanding all inner walls so I can epoxy for the seats to be installed. The stern cover’s bottom was also epoxied today.   The bow cover was fitted with sanding because it wasn’t sitting properly. Today was very efficient and full of successful prep. Can’t wait to install my seat tomorrow. The three pieces I add tomorrow will be the last addition of wood to my boat. After I piece my boat together, I will have a smooth rest of the week sanding and epoxying the entirety of my boat. Still thinking of some names for my boat. My two favorites are: 1. blub blub blub 2. Titanic 2 Comment down below other names you recommend! Stop by to see my progress anytime! Thanks for reading, Calvin Monfried Hours: 6             
Read more

SEAT DAY #2

Image
Today was very similar to yesterday. After flipping the boat, I mixed up my epoxy and epoxy hardener and added a ton of wood flour to have the peanut butter consistency that I used yesterday. I set up a sandwich bag and scooped all the mixed epoxy into the bag like yesterday. Using a box cutter, I cut off the corner of the sandwich bag like yesterday. I told you it was all very similar to yesterday. The only thing different was the location of the fillets. This time I was filleting on the bottom crease of the covers and seat.  I wish I told you I didn’t go to Pizza Chef again, but that would be a lie too. With easy access to the top of the boat, I grabbed the sander and sanded.  I also grabbed the heat gun and scraped away at a few globs.  Hopefully, we don’t have another groundhog day like today!  Happy "EEARTH" Day!  Feel free to stop by anytime to see my progress! Thanks for reading,  Calvin
Read more